Advertisement
7
When microphone placement is complete, get out of the vehicle, and close all doors,
windows and sunroof. Then, start measurement by double-clicking the Measure
button on the IMPRINT SOUND MANAGER screen. Do not open the doors until
"Complete" is displayed on the screen and signal sound is output from the speakers
and sound characteristics are measured in the vehicle. If noise enters from outside
during measurement, "Error" will be displayed on the screen. If displayed, measure
again by double-clicking the Measure button.
• Perform PC operation outside the vehicle.
• Removing the microphone during calibration may cause an error.
8
After measuring the first microphone position, move the microphone to the next
location indicated by the on the screen graphic. Repeat the procedure in step 7
following the on screen instructions.
• Preforming measurement from two locations in the car should be sufficient. If you want to finish after two
measurement locations, double-clicking the Result button, and move to the Target Curve setting.
• For more precise measurement, 6 measurement locations are available; however, it will take approx. 20 minutes
until all MultEQ measurements have been completed. In this case, be sure to perform MultEQ measurement
with the vehicle connected to a car battery charger.
9
After all desired mic position measurements are complete, double-click the Result
button to make the Target Curve selection. This curve sets the overall sound
characteristics of the system. Select the Target Curve Select from the on screen
choices.
• The measurement data cannot be stored on the PC hard disc, but can be memorized in the PXA-H100.
Autogood products internet store http://130.com.ua
5
-EN
Advertisement
