Huawei Quidway S3000-EI Series Operation Manual page 3

Operation Manual - Remote Power-feeding
Quidway S3000-EI Series Ethernet Switches
S3026C - PWR S3026C - PWR
E0/1 E0/1 E0/1 E0/1
S2016C S2016C S2016C S2016C
Figure 1-1 Remote power-feeding
You can input command lines to enable/disable remote power-feeding on a port, adjust
its power-feeding mode and PD detection mode, and set its power-feeding priority and
compatibility testing fun
perform reverse detection on the
S3026C-PWR to supply power to PDs on spare lines and signal lines simultaneously.
Table 1-1 Configuring remote power-feeding
Device
S3026C-
PWR
Network Network Network Network
E0/24 E0/24
E0/24 E0/24
E0/2 E0/2
E0/2 E0/2
AP AP AP AP AP AP AP AP
ctionality. As such, you can also press the "mode" button to
Configuration
Enable remote
power-feeding on a port
Press the mode button
to detect power-feeding
on a port
Select the
power-feeding mode on
a port
Set the maximum
power on
power-feeding port
Setting power
management mode
and Power-Feeding
Priority on a Port
Enable/Disable the
compatibility detection
on a port
Reset the PoE
configuration on the
switch
Upgrading the PoE
Daughter-C ard
Huawei Technologies Proprietary
Chapter 1 Remote Power-Feeding Configuration
PDs connected to an S3026C-PWR and allow the
Default
Enabled
-
Power-f eeding through
signal line s
an 15400 milliwatt
power management
mode is manual mode
Priority of a Por t is Low
Disabled
-
-
1-2
Description
-
-
You can adjust the
po wer-feeding
mode if nece ssary.
You can adjust this
m aximum
according to the
power on the PDs
in practice.
-
-
Yo u can restore
default PoE
configuration on
the current switch.
-