Toshiba teli BG030 Instruction Manual page 61

● Setting
- Set the IP Configuration
Set the following value to "GevCurrentIPConfigurationLLA", "GevCurrentIPConfigurationDHCP",
"GevCurrentIPConfigurationPersistentIP" registers. These setting values are Boolean type.
Set these registers in conformity with your system.
- Set the camera access privilege of an application.
Set the following value to "GevCCP" register. The setting value is Enumeration type.
You can configure multi host system by using this function.
setting value
OpenAccess
ExclusiveAccess (*)
ControlAccess
- Set the Packet Size of the stream channel
Set the following value to "GevSCPSPacketSize" register. The setting value is Integer type.
Set the register in conformity with your system (NIC, Switching HUB and the network condition). If the
register setting is not in conformity with your system, your host can not grab the image properly.
Notes on packet size setting:
When the packet size setting is less than 1500[byte/packet], image may not be captured properly (e.g. dropping frames).
In this case, change the packet size more than 1500[byte/packet].
And we recommend you to use network equipments (NIC, Switching HUB, etc. ) supporting Jumbo Frame.
Copyright © 2012 TOSHIBA TELI CORPORATION, All rights reserved.
setting value
FALSE
TRUE
Secondary access that can only monitor the image and read the register. (MonitorAccess)
Primary access that can monitor the image and control the register.
Other host can not access the camera.
Primary access that can monitor the image and control the register.
Other host can have privilege of Secondary access only.
PacketSize
Minimum
Maximum
* initial factory setting = 1500[byte/packet]
IPConfiguration
Inactive
Active
Access Right
setting value
72[byte/packet]
16364[byte/packet]
60 / 69
* initial factory setting
D4211908D
http://www.toshiba-teli.co.jp/index.htm