Advertisement
Shaving Tips
Cleaning & Care
■ Ensure your skin is dry and free of oils.
■ Wait at least 15 minutes after getting up before shaving, to ensure your face is
The shaver is a washable appliance. The head
free of puffiness that may be present from sleeping.
assembly part may be cleaned under warm water.
■ Always hold the shaver at a right angle to the skin so that all three heads are
touching the skin with equal pressure.
IMPORTANT:
■ Stretch skin with the free hand so hairs stand upright, making it easier for them
to enter the cutting chamber.
cutting system. Do not attempt to disassemble the cutters as this will
reduce their effectiveness and void your warranty. To maintain peak perfor-
■ Use moderate to slow, circular stroking movement.
mance, follow the daily and weekly cleaning instructions below.
■ The use of short, circular motions in stubborn areas may obtain a closer shave,
especially along the neck and chin line.
NOTE: **When cleaning your shaver, make sure the shaver is disconnected
■ Do not press hard against the skin to avoid skin irritation and/or damage to the
from the power cord.**
rotary heads.
**Remington recommends that you use your new shaver daily for up to four
CAUTION!
weeks to allow time for your hair and skin to become accustomed to the
■ To clean the external surfaces of the shaver, use a damp cloth. Do not use strong
new shaving system**
detergents or other chemicals.
■ To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer
Trim
or heater to dry the shaver.
■ The shaver should not be used until it has dried.
F
G
H
I
1. Pull trimmer release button to engage trimmer. (Diagram F)
2. Trim long, difficult hairs and side burns. (Diagram G)
3. Close trimmer by pressing down. (Diagram H)
M
Q
Daily:
1. Press the release button on front of shaver and open head assembly. (Diagram I)
2. Tap out excess hair shavings. (Diagram J)
3. Rinse the head of the shaver in running water. (Diagram K)
NEVER submerge the shaver in water!
4. Close head assembly. (Diagram L)
Weekly:
**The head assembly of your rotary shaver is a precision
1. Perform the daily cleaning steps 1 and 2.
2. Place a drop of liquid dish soap on the inside near each cutter. (Diagram M)
3. Apply a small amount of water to each cutter. (Diagram N)
4. Close the head assembly. (Diagram L)
5. Turn the shaver on allowing it to run for several seconds. (Diagram O)
6. While the shaver is running, use your finger to flex the shaver heads multiple
times working the soap into a lather. (Diagram P)
7. Turn the shaver off. (Diagram O)
8. Open the head assembly and rinse thoroughly with water. (Diagram K)
9. Gently shake off excess water, close head assembly, and allow to dry.
(Diagram Q)
**Trimmer: Lubricate teeth with oil every six months.
Replacing Cutters
IMPORTANT:
DO NOT attempt to disassemble the cutters. Replacement of
new cutters requires a new head assembly.
J
K
L
Battery Removal
When your rechargeable shaver reaches the end of its useful life, the Ni-MH bat-
N
N
O
P
teries must be removed from the shaver and be recycled or disposed of properly
in accordance with your state and local requirements. If this is not required by
law, you may elect to dispose of the shaver with the batteries.
CAUTION! Do not put in fire or mutilate your batteries when disposing as they
may burst and release toxic materials. Do not short circuit as it may cause burns.
Dispose of properly in accordance with your local and state requirements.
■ Because your satisfaction is important to us, we want to make it simple for you
To Remove the Rechargeable Battery:
to keep your new shaver performing at its peak.
1. Unplug the shaver.
■ Did you know that for the best possible shave, it is necessary to replace the
2. Run shaver until motor stops.
heads and cutters on your shaver every 12 months?
3. Remove head from shaver (Press release button and pull head straight away
■ Remington makes this easy!
from shaver body)
4. Using a small screwdriver pry front cover from shaver body.
Two Easy Ways to Order!
5. Remove four screws located on front of shaver.
1. U.S. Residents call 1-800-392-6544
Canadian Residents call 1-800-268-0425
6. Remove rear cover from inner housing to expose batteries.
2. Order Online at www.RemingtonProducts.com
7. Pry batteries free from circuit board and cut wires.
8. Dispose of batteries.
Product Registration
By registering your new Remington
®
product you will receive these important
Warranty
benefits:
■ Proof of ownership
Limited Two-Year Warranty
■ Product protection
Spectrum Brands, Inc. warrants this product against any defects that are due to faulty
■ Product registration
material or workmanship for a two-year period from the original date of consumer
■ Special offer
purchase. This warranty does not include damage to the product resulting from acci-
dent or misuse. If the product should become defective within the warranty period, we
Register online at: www.RemingtonProducts.com
will replace it free of charge. Return your product and sales receipt with your name,
address and day time phone number to: Remington Returns Center, 507 Stokely Dr.,
How To Order Shaver Accessories
P.O. Box 1, Deforest, WI 53532. For more information call 800-736-4648 in the
U.S. or 800-268-0425 in Canada.
Please refer to the shaver comparison and features chart near the front of
Warranty excludes:
this manual that lists the correct replacement part number for your shaver.
■ Heads and cutters
It is very important to replace your head and cutters when necessary to ensure
KEEP ORIGINAL SALES RECEIPT AS PROOF OF PURCHASE FOR WARRANTY
a close, comfortable shave without irritation. We recommend they be replaced
PURPOSES.
every 12 months. Here are some signs of head and cutter wear, indicating that
replacement is needed:
This warranty does not cover products damaged by the following:
■ Irritation: As the heads get excessively worn you may experience some skin
■ Accident, misuse, abuse or alteration of the product
irritation. This would be especially noticeable when you apply moisturizing lotion.
■ Servicing by unauthorized persons
■ Pulling: When the cutters wear you may feel a sense of pulling and a loss of
■ Use with unauthorized accessories
closeness when you shave. This is an indication that it is time to replace your
■ Connecting it to incorrect current and voltage
heads and cutters.
Maintain your shaver's peak performance!
■ Wrapping cord around appliance causing premature wear & breakage
Keep Your Shaver Performing Like New!
■ Any other conditions beyond our control
SPECTRUM BRANDS, INC. SHALL NOT BE RESPONSIBLE FOR ANY INCIDENTAL,
SPECIAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS
PRODUCT. ALL IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO IM PLIED
WARRANTIES OF FITNESS AND MERCHANTABILITY, ARE LIMITED IN DURATION TO
TWO YEARS FROM DATE OF ORIGINAL PURCHASE.
This warranty gives you specific legal rights and you may also have other rights
which vary from state to state or province to province. Some states do not allow the
exclusion or limitation of incidental, special or consequential damages.
Performance Guarantee
Spectrum Brands, Inc. Money-back Offer
If within 30 days after you have purchased your Remington
®
branded product, you
are not satisfied and would like a refund, return it with the sales slip indicating
purchase price and date of purchase to the retailer from whom it was purchased.
Spectrum Brands, Inc. will reimburse all retailers who accept the product within 30
days from the date of purchase. If you have any questions concerning the money-
back guarantee, please call 800-736-4648 in the US or 800-268-0425 in Canada.
Questions or comments: Call 800-736-4648 in the US or 800-268-0425 in
Canada. Or visit www.RemingtonProducts.com
Dist. by: Spectrum Brands, Inc., Madison, WI 53711
Dist. by: Spectrum Brands Canada, Inc., 4180 Sladeview Crescent,
Mississauga, ON L5L 0A1
Remington is a Registered Trademark of ROVCAL, Inc. a subsidiary of
Spectrum Brands, Inc.
© 2010 ROVCAL, Inc. 08/10 Job #CS40442
Manufactured to Remington's specifications in the PRC.
T22-30689
Contains
listed adaptor
Contient un
adaptateur
homologué UL
Advertisement
