1. Manuals
  2. Brands
  3. GGP Manuals
  4. Tractor
  5. 13-6216-14
  6. Instructions manual

GGP 13-6216-14 Instructions Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
1
2
3
S
5
4
2

Advertisement

Table of Contents
loading

Summary of Contents for GGP 13-6216-14

  • Page 2 D, E...

  • Page 6: Safety Instructions

    ENGLISH b. On slopes, it is not possible to control a 1 GENERAL sliding ride-on lawnmower by braking. The main reasons for losing control are insufficient This symbol indicates WARNING. Seri- traction, excessively high speed, insufficient ous personal injury and/or damage to braking, the machine not being suited to the property may result if the instructions task, lack of attention to the surface or incorrect...
  • Page 7 ENGLISH • Before use, always check that blades and • Watch out for holes in the ground and other mounting devices are not worn or damaged. hidden dangers. Replace worn or damage parts as a set so that • Do not drive too near ditches or high edges. the correct balance is maintained.

  • Page 8: Maintenance And Storage

    ENGLISH a. To remove sticks and rubbish or when the • Always use genuine spare parts. Non-genuine discharge has become clogged. spare parts can entail a risk of injury, even if b. To check, clean or service the machine. they fit the machine. c.

  • Page 9: Accessories Bag

    ENGLISH At the correct storage temperature, the battery 3.2.2 Closing should be maintenance-charged every four 1. Grasp the front edge of the engine casing and months. fold down the casing (fig. 4). The battery acid is extremely corrosive 2. Secure the front edge of the casing with the rub- and can cause injuries and damage to ber strap (fig.

  • Page 10: Safety System

    ENGLISH 1. Install the steering column jacket on the steer- 4 DESCRIPTION ing column and secure by knocking in the ten- sion pin (C) approximately 1/3 of its length. 2. Pull the steering column jacket and the steering 4.1 Transmission column up.
  • Page 11 ENGLISH 4.4 Controls Unlocking: Press and release the pedal (12:B). 4.4.1 Implement lifter, mechanical (10:A) 4.4.5 Driving-service brake (10:F) To switch between working position and transport position: (4135H, 4155H) 1. Depress the pedal fully. If the machine does not brake as expect- 2.

  • Page 12: Areas Of Use

    ENGLISH 2/3. Operating position. 4.4.11 Seat (16:S) The seat can be folded and is adjustable front-rear. The seat is locked in the folded 4. Start position – the electric start motor up position using the catch (12:K) and ad- is activated when the key is turned to the justed front-rear using the knobs (12:J).

  • Page 13: Checking The Engine Oil Level

    ENGLISH Petrol is highly inflammable. Always 6.4.1 General safety check store fuel in containers that are made especially for this purpose. Object Result Only fill or top up with petrol outdoors, Fuel lines and con- No leaks. and never smoke when filling or top- nections.

  • Page 14: Operating Tips

    ENGLISH 6.8 Cleaning 6. Depress the clutch-brake pedal fully. 7. Turn the ignition key and start the engine. To reduce the risk of fire, keep the en- 8 Once the engine has started, move the throttle gine, silencer, battery and fuel tank free control gradually to full throttle (approx.
  • Page 15 ENGLISH Use oil of service grade SF or higher in accordance 7.5.2 Draining with the table below. 1. Run the machine at variable speeds for 10-20 minutes to heat up the transmission oil. 2. Position the machine completely horizontally. All temperatures SAE 10W-40 3.

  • Page 16: Belt Transmissions

    ENGLISH 5. Set the accelerator pedal to the forward position The battery must be fully charged be- by blocking it using a wooden wedge. See fig. fore being used for the first time. The 23. Fill the oil reservoir by hand using new oil. battery must always be stored fully charged.

  • Page 17: Air Filter, Engine

    ENGLISH 7.12 Lubrication 7.8.4 Cleaning If the battery terminals are coated with oxide, they All lubrication points in accordance with the table should be cleaned. Clean the battery terminals with below must be lubricated every 50 hours of opera- a wire brush and lubricate them with terminal tion as well as after every wash.

  • Page 18: Product Identity

    • Clean the air filter according to the instructions 2. The engine’s model, type and serial numbers: given (see user instructions). Found on the machine’s fan housing as illustrated: GGP reserves the right to make alterations to the product without prior notification.
  • Page 19 3. 13-6102 + 13-2939 7. 13-6104 + 13-2933 4. 13-6102 + 13-2927 8. 13-6104 + 13-2924 10.Serial number See label on chassis 4.Manufacturer GGP Sweden AB P.O. Box 1006 SE-573 28 Tranås 11. Engine Sweden 5.Vibration < 0.9 m/s Make Briggs &...

Table of Contents