Basic Troubleshooting; Diagnostic Flash Codes; Throttle Control Lever - Pride Mobility Sonic Owner's Manual

X . B A S I C

DIAGNOSTIC FLASH CODES

NOTE: Your scooter will not run unless the flash code condition is resolved and the scooter
has been turned off, then turned back on.
FLASH CODE
n n
n n n
n n n n n
n n n n n n
n n n n n n n
n n n n n n n n
n n n n n n n n n
What if all the systems on my scooter seem to be “dead”?
n
n
n
n
n
What if the motor runs but my scooter does not move?
n
n
n
What if the battery condition meter dips way down and the motor surges or hesitates when I press the

throttle control lever?

n
n
Sonic/RevA/May 2004
T R O U B L E S H O O T I N G
CO NDITION
Batteries are too low to operate the scooter
or the charger is operating.
The scooter's battery voltage is too
high to operate the scooter.
Solenoid brake trip: the manual freewheel
lever is in the freewheel position.
W igwag fault; your throttle control lever is
not responding.
Speed pot fault: speed adjustment dial is
not responding.
The scooter's motor is disconnected.
Possible controller trip-the scooter is hot
and the scooter seems to be losing power.
www.pridemobility.com
SOLUTION
Charge batteries or unplug the charger power cord
from the electrical outlet.
Insert the key into the key switch, turn the
scooter's light on to drain power from the
batteries.
Turn the key to the "off" position, then push the
manual freewheel lever to the (forward) drive
position, restart your scooter.
Call your authorized Pride P rovider for assistance.
Call your authorized Pride P rovider for assistance.
Check the front-to-rear harness connection— call
your authorized Pride Provider for assistance.
Shut down your scooter for a minimum o f several
minutes to allow the controller to cool.
33