Related Manuals for Broadcast Devices AES-200
Summary of Contents for Broadcast Devices AES-200
- Page 1 Broadcast Devices, Inc. Technical Reference Manual AES-200 Digital Audio Switcher/DA Broadcast Devices, Inc. 5 Crestview Avenue Cortlandt Manor, NY 10567 Tel. (914) 737-5032 Fax. (914) 736-6916 Rev B. 10/97...
-
Page 2: Table Of Contents
Installation ........................1 Remote Control Connection ................... 2 II. Specifications ........................3 III. Schematic Diagrams AES-200 Simplified Block Diagram ................4 Digital Distribution Amplifier Board ................5 CDR-200 Digital Switching Input Board ............... 6 BPS-300 Power Supply Board ..................7... -
Page 3: Unpacking And Inspection
The AES-200 itself can drive up to 25 foot cables with no degradation of the signal. It is advisable however to keep output cable from the AES-200 as short as is practical. -
Page 4: Remote Control Connection
REMOTE CONTROL The AES-200 is fully remote controllable via a rear panel 9 pin DE connector. In addition to remote control of the channel switching function, channel status is available. The control pins (3 and 4) are ground start and require only a momentary connection to ground for actuation. The status pins (7 and 8) are dry isolated contacts that provide a closure to status common pin number (6) that can be user configurable for either voltage or ground status. -
Page 5: Specifications
II. SPECIFICATIONS Number of Inputs 2 - Balanced Number of Outputs 2 - Balanced AES/EBU Standard, 2 - Unbalanced B.N.C. Input Connectors 2 - XLR - Female - AES/EBU Standard Output Connectors 2 - XLR - Male - AES/EBU Standard 2 - Unbal. B.N.C. Input/Output Impedance 110 Ohms Balanced 55 ohms for unbalanced outputs... -
Page 6: Schematic Diagrams
III. SCHEMATIC DIAGRAMS... -
Page 11: Warranty
IV. WARRANTY Broadcast Devices, Inc. products are warranted against failure due to faulty workmanship or materials for a period of one year from date of shipment to the customer. The warranty covers repair or replacement of defective parts at the factory, provided the unit has been returned by the customer , via prepaid freight under a return authorization obtained from the factory.