Receiver Connections Explained; Binding - Carson Reflex Wheel Ultimate Touch 2.4g Instruction Manual

Receiver connections explained

Binding

The receiver supplied is already bound to the
transmitter. If you would like to bind a new
receiver to the system, please proceed as follows:
1. Install the battery in the transmitter and switch
on the remote control.
2. Open the main menu and select the "RX Set-up"
function on the second menu page and then
press "Bind with a receiver" to start the binding
procedure.
3. Insert the binding cable into the RX connection
"B/VCC".
4. Connect a 6V battery to any channel from CH1 to
CH4. Ensure correct polarity. The receiver LED will
start to flash.
Receiver
CARSON Reflex Wheel Ultimate Touch 500500516
Binding connector
CH1-CH4: Connection to the relevant channel
(servo/ESC, etc.)
BIND, VCC: Connection for binding connector and
power supply.
OUT: ASbus connection for outgoing PPMS
data signals and for connecting the
serial bus module to extend the
channels further.
IN: Connection for all types of sensors.
5. The transmitter will end the bind mode automa-
tically once the receiver has been successfully
connected to the transmitter.
6. Unplug the binding cable and reconnect the
receiver to the battery. Please connect the servos
and sensors to the receiver and check all the
functions.
7. If the functions should fail to work properly,
you will need to repeat the above steps again.
RX battery
GB
61