Pppoe (Dsl) - D-Link DIR-820L User Manual

Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a
username and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your
computer. The software is no longer needed and will not work through a router.
Select PPPoE (Username/Password) from the drop-down menu.
My Internet
Connection:
Select Static IP if your ISP assigned you the IP address, subnet mask,
Address Mode:
gateway, and DNS server addresses. In most cases, select Dynamic.
Enter the IP address (Static PPPoE only).
IP Address:
Enter your PPPoE user name.
User Name:
Enter your PPPoE password and then retype the password in the next box.
Password:
Enter the ISP Service Name (optional).
Service Name:
Select either Always-on, On-Demand, or Manual.
Reconnect
Mode:
Enter a maximum idle time during which the Internet connection is
Maximum Idle
maintained during inactivity. To disable this feature, enable Auto-reconnect.
Time:
Enter the Primary and Secondary DNS Server Addresses of your choice.
DNS Servers:
Maximum Transmission Unit - you may need to change the MTU for optimal
MTU:
performance with your specific ISP. 1492 is the default MTU.
MAC Address:
The default MAC Address is set to the Internet port's physical interface MAC address on the Broadband Router. It is not recommended
that you change the default MAC address unless required by your ISP. You can use the Copy Your PC's MAC Address button to
replace the Internet port's MAC address with the MAC address of your Ethernet card.
D-Link DIR-820L User Manual
Internet Setup

PPPoE (DSL)

23