Additional Information; Mounting The Base On A Wall; Using The Belt Clip; Troubleshooting And Maintenance - Radio Shack Presidian User Manual

7) Additional Information

7) Additional Information

7-1. Mounting the Base on a Wall

7-1. Mounting the Base on a Wall
You can mount the phone on any standard telephone jack wall plate.
1.
Route the AC adapter and the modular
cords through the hole of the wall mount
bracket (supplied).
2.
Connect the AC adapter and the modular
cords as shown. Remember to route the
AC adapter cord through the channel.
3.
Line up the four tabs on the wall mount
bracket (two at the top and two at the bottom) with the
four notches on the bottom of the base. Slide the bracket
into place.
4.
Hook the AC adapter cord into the smaller notch at the bottom of the bracket, and let
the cord hang below the bracket.
5.
Plug the modular cord into the wall jack. Hook both sides of the modular cord into the
larger notch OR tuck the excess cord into the open space in the bracket.
To AC outlet
AC adapter (supplied)
6.
Place the mounting slots over the pins on the wall plate.
7.
Slide the base to lock it into place.
Note: To mount the phone directly on the wall, insert two
1-3/8 inch, #10 screws (not supplied) into the wall using
anchors suitable for the wall material. Place the screws
3-15/16 inches apart, and allow 1/8 inch free space between
the wall and screw heads.
Removing the Base from the Wall Mount Bracket Removing the Base from the Wall Mount Bracket
While pulling the release latch on the bracket
with one hand, slide the base away from the
bracket.

7-2. Using the Belt Clip

7-2. Using the Belt Clip
To attach the belt clip To attach the belt clip
Insert the tabs on the side of the belt clip (supplied) into the
holes on either side of the handset. Press the belt clip down until
it clicks into place. (Tug on the clip to make sure it's secure.)
To remove the belt clip To remove the belt clip
Gently pull the tabs out of the holes, then slide the belt clip off of
the handset.

7-3. Troubleshooting and Maintenance

7-3. Troubleshooting and Maintenance
Solving Common Issues Solving Common Issues
If your phone is not performing to your expectations, please try these simple steps fi rst.
If these steps do not solve your problem, take it to your local RadioShack store for
assistance.
Wall plate
To telephone
wall jack
Modular cord (supplied)
Wall plate
13
Release latch Release latch