Table of Contents
Advertisement
Installation of protector for wireless LAN unit
1. Remove the screws for securing the protector at
the top of the USB Port where the wireless LAN
unit is going to be connected.
NOTE:
• The wireless LAN unit can be inserted into either
USB Port 1 or USB Port 2.
CAUTION:
• Do not lose the removed screws. Do not leave them
inside the device as well.
2. Insert the wireless LAN unit to the USB Port.
3. Attach the protector for the wireless LAN unit. At
this point, fit the two studs on the protector into
the two square holes on the front panel of the
product.
4. Securely fasten the protector with the screws.
(tightening torque 4.7N•cm - 7.3N•cm)
CAUTION:
• Do not apply a force higher than the specified force
when tightening the screws. This may result in
damages to the screw holes.
English-11
Advertisement
Table of Contents
