General - Sony XDR-F1HD Service Manual

A
DISPLAY BAND SCAN HD SCAN
L
RESET
R
AUDIO OUT
?/1
SLEEP
AM FM
B
Size AAA (R03)
× 2
SECTION 1

GENERAL

PRESET PRESET
MENU TUNE TUNE ENTER
SELECT
ANTENNA
AM FM
AC power cord
SLEEP
1 2 3
4 5 6
7 8 9
0
ENTER
PRESET
HD SCAN
TUNE/
SELECT SCAN
BAND
MENU BRIGHT DISPLAY
The number 5 and the PRESET +
buttons have a tactile dot.
Preparing the remote
commander
Installing the batteries into the remote com-
mander (See Fig. B)
Insert two size AAA (R03) batteries (not supplied).
When to replace the batteries
With normal use, the batteries should last for about
six months. When the remote commander no longer
operates the unit, replace all the batteries with new ones.
Notes
• Do not charge dry batteries.
• When you are not going to use the remote commander
for a long time, remove the batteries to avoid any
damage caused by leakage and corrosion.
Setting the clock
1
Plug in the unit.
2
Press MENU to show the menu display.
3 Press SELECT M or m to select "TIME SET, "
then press ENTER.
4 Press SELECT M or m until current hour
appears in the display, then press ENTER.
5
Repeat step 4 to set the minute.
Note
If you do not set the menu within 65 seconds, the setting
mode is canceled.
To change the display to the
daylight saving time (summer
time) indication
1
Press MENU to show the menu display.
2 Press SELECT M or m to select "DST, " then
press ENTER.
3 Press SELECT M or m to select "ON, " then
press ENTER.
" " appears and the time indication changes to
summer time.
To deactivate the DST function, select "OFF" in step 3.
XDR-F1HD
This section is extracted
from instruction manual.
Playing the radio
–Manual tuning
Press ?/1 to turn on the radio.
1
2
Press BAND to select the band AM or FM.
3
Press TUNE + or – to tune in to a desired
frequency.
Note
of the remote commander.
–Preset tuning
You can preset 20 stations each for AM and FM.
Presetting a station
1
Follow steps 1 to 3 in "Manual tuning" to tune
the frequency you wish to preset.
2
Press and hold ENTER for a few seconds.
FM
3
Press PRESET + or – to select the preset
number, then press ENTER.
number.
To preset another station, repeat these steps.
Note
If you try to store another station in the same preset
number, the previously stored station will be replaced.
Tuning in to a station
Press ?/1 to turn on the radio.
1
2
Press BAND to select the band AM or FM.
3
Press PRESET + or – to select the desired
preset number.
Tip
of the remote commander. Press ENTER
number is selected.
–Scan tuning
In HD scan, HD Radio stations are scanned.
Press ?/1 to turn on the radio.
1
2
Press BAND to select the band AM or FM.
3
Press SCAN or HD SCAN on the unit or
remote commander.
Scanning of the selected band starts.
When a station is received, scanning pauses for 3
seconds and then continues.
4
When the unit tunes in to the desired station,
do any of the following operations to stop
scanning.
– Press ENTER on the unit or remote commander.
– Press SCAN or HD SCAN.
5
If necessary, press TUNE + or – to tune in to
the station more precisely.
3