How To Assemble And Use; Operating Your Therapure® 300D; Control Panel - Therapure 1040808 Owner's Manual

300

how to assemble and use

Please note: make sure the permanent hEPa-type filter is properly installed before use.
1. Keep both sides of the unit more than 4 inches away from a wall.
2. Do not blow air from a fan or air conditioner directly into the air purifier.
3. Do not place the unit where the air inlet or outlet grill could come in contact with a curtain.
4. Placing the unit close to the source of air pollution can improve indoor air quality effectively.
1.
3.
6
2.
4.
operating your therapure® 300d
Plug the unit into an electrical outlet. The unit will be ready to run. Read the following directions
to select desired settings.

ConTRol PanEl

1. Press the on/oFF button to turn on your air purifier and press it again to turn it off.
2. When the air purifier is turned on, the fan will run at low speed (this is the default speed).
Press the SPEED button to cycle through the fan speeds shown below:
loW MEDIuM
3. While the fan is running, press the TIMER button to the select the desired run time
(in hours) as shown below:
1h 2h 3h
TIME oFF 12h
4. Press the Ion button to turn on the ionizer while the fan is running and press it again
to turn off the ionizer.
5. Press the uV/VoC button to turn on the germicidal light and filter. Press it again to turn off.
hIGh QuIET
4h 5h 6h 7h
11h 10h 9h 8h
7