JVC KD-G351E Service Manual page 25

3.2.13 Removing the loading roller assembly
(See Figs.19 to 21)
• Remove the top cover, base board, chassis unit, clamper assembly
and top plate assembly.
(1) From the left side of the chassis unit, remove the screw J
attaching the lock arm assembly. (See Fig.19.)
(2) Remove the projection ap of the lock arm assembly from
the joint aq while opening the cam plate R in the direction
of the arrow. (See Fig.19.)
(3) Remove the lock arm assembly from the projection ar of
the chassis unit. (See Fig.19.)
(4) Remove the projection as of the lock arm assembly from
the joint at of the cam plate L assembly. (See Fig.19.)
(5) From the right side of the lock arm assembly, remove the
loading roller spring L from the section au. (See Fig.20.)
(6) From the top side of the lock arm assembly, remove the loading
roller spring R in the direction of the arrow and remove the loading
roller assembly. (See Fig.20.)
(7) Remove the roller guide R, HL washer and roller guide L
from the both ends of the loading roller assembly. (See
Fig.21.)
Cam plate R
aq
J ap
Lock arm assembly
Fig.19
Loading roller assembly
Lock arm assembly
Loading roller
spring L
au
Fig.20
Roller guide L
Loading roller assembly
Fig.21
Chassis unit
Cam plate L assembly
at
ar
as
Loading roller spring R
Roller guide R
HL washer
(No.MA377<Rev.004>)1-25