Advertisement
OPERATION
The on/off switch is incorporated in the rotary switch in the motor housing.
0- The Fan is switched Off
1- The Fan operates at the lowest speed
2- The Fan operates at the medium speed
3- The Fan operates at the highest speed
•
The fan can operate in oscillation or static mode.
•
To make the fan head oscillate, push down the Oscillation Knob.
•
To stop the fan head from oscillating, pull-up the Oscillation Knob.
•
T he head of the fan can be adjusted up or down, to do this loosen the adjusting
knob, adjust the fan to the desired angle, to secure tighten the adjusting knob.
ASSEMBLY:
If your fan comes ready assembled ignore this part.
1. Remove the parts from the packing. Separate the front and rear guard if they
are connected.
2. Set the rear grille in the proper position with handle up.
3. Screw on plastic nut tightly to attach grille.
4. Loosen the set screw on the blade, slide the blade onto the shaft of the motor,
tighten the set screw onto the flat of the shaft to secure the blade. Ensure that
the blade does not foul the guards.
5. Assemble the front guard to the rear guard. Tighten the connecting screw and
nut, secure the retaining clips.
ASSEMBLY DIAGRAM:
Oscillation Knob
Switch Knob
Power cord
Adjusting knob
NOTE: Some interference may be heard over some radios, when switching speeds,
this is normal for this type product.
Rear Guard
Motor
Base
Set Screw
Blade
Screw
Front Guard
Screw
Nut
Advertisement
