JVC MX-GB6 Service Manual page 11

3.1.3 Removing the front cabinet assembly
(See Figs.11 to 14)
• Prior to performing the following procedures, remove the top
cabinet and CD changer mechanism assembly.
(1) From the forward side of the main board, disconnect the
card wire from the connector CW101. (See Fig.11.)
(2) Disconnect the wires from the connectors (CW01A,
CW108, CW109, CW111, CW112) on the main board.
(See Fig.11.)
(3) From the top side of the main body, remove the screw F at-
taching the earth wire. (See Fig.12.)
(4) From the both sides of the main body, remove the two
screws G attaching the front cabinet assembly. (See
Figs.12 and 13.)
(5) From the left side of the main body, remove the screw H at-
taching the front cabinet assembly. (See Fig.13.)
(6) From the bottom side of the main body, remove the screw
J attaching the front cabinet assembly. (See Fig.14.)
(7) Release the two joints a and two joints b, remove the front
cabinet assembly in the direction of the arrow. (See Figs.12
to 14.)
CW101
CW01A
Card wire
CW109 Wire Wire
Front cabinet assembly
a
G
Main board
Wire
Wire
CW112
CW111
CW108 Wire
Fig.11
F
Earth wire
Fig.12
Front cabinet assembly
G
Fig.13
Front cabinet assembly
J
b
Fig.14
(No.MB160)1-11
H
a