Table Of Washing Programs - White Knight WM105M Instruction Manual

Operating Instructions

Table of Washing Programs

Load(kg) Detergent Box
Compa- Compa-
6.0
rtment II
rtment I
1.5 1.5
Cotton Intensive
6.0
6.0
0 0
6.0
3.0
1.5 1.5
6.0
The energy class is A+
The energy test program: Cotton Intensive 60°C/40°C;
Half load for 5.0kg/6.0kg machine: 2.5kg/3.0kg
The "Cotton Intensive 60°C/40°C" are the standard washing programs to which the information on
the energy label and product fiche relates. These programs are suitable to clean normally soiled
cotton laundry. They are the most efficient programs in terms of combined energy and water
consumption.
●
required
○
optional
not necessary
Note: The above parameters are for reference only. The cycle time will depend on the temperature
selected and the load
Note: If the mains supply should go off during a wash cycle the machine will stop, but when the mains
supply comes back on the program will continue. Pressing the "Power" button will not cancel the current
program. To select a different program, press the "Start/Pause" button, select the required program
and then press the "Start/Pause" button again.
If the machine is left powered up it will consume 1.25W for 40 minutes. The machine will then revert to
the 'off-mode' and will consume 0.39W until the power is switched off.
Note: At the end of the cycle the door will remain locked for up to 2 minutes. Do not try to force
the door open.
Default
Default Time
Temp.( C)
(Min)
5.0/6.0kg 5.0 6.0 1000 1200
Cold 15 15 1000 1200
40 140 160
1000 1200
NA 15 15 1000 1200
90 90 75 500 400
60 130 120
1000 1200
40 105 100 700 800
85 80
40 500 400
40 108 110 1000
1200
P.16
Maintenance
Before commencing any cleaning or maintenance, please remove the plug
and turn off the water supply.
-Solvents must not be used as they could damage the washing machine or toxic/explosive
gases could be generated.
-Do not pour water onto the washing machine.
-Do not use detergents containing PCMX to clean the washing machine.
Cleaning and Maintenance of the Washing Machine Cabinet
Proper maintenance of the washing machine can extend its working life.
The surface can be cleaned with diluted, non-abrasive, neutral detergent,
when necessary. If there is any water overflow, use a dry cloth to wipe it off.
Note: Formic acid and its diluted solvents or equivalent should not be used.
Cleaning inside the Drum
Any rust left inside the drum by metal articles must be removed immediately with
chlorine-free detergent.
Never use steel wool.
De-frosting a Frozen Washing Machine
When the temperature drops below zero and your washing machine freezes up, you may:
1.Disconnect the power from the machine.
2.Wash the tap with warm water to loosen the inlet pipe.
3.Disconnect the inlet pipe and immerse it in warm water.
4.Pour warm water into the drum and wait for 10 minutes.
5.Reconnect the inlet pipe and check that there are no water leaks.
Note: When the washing machine is reused, ensure that the ambient temperature is above 0°C.
Preventing the Machine from Freezing Up
If your washing machine is located in a room where it may freeze up, please thoroughly drain
the water from the inlet pipe and the outlet drain hose.
To remove the water from the drain pump, carefully remove the pump cover as shown and
collect the water in a tray.
To prevent scalding, allow any water in the machine to cool
down before removing the pump cover.
P.17