Getting To Know Your Fan; Assembly - Airworks 12MDWA Owner's Manual

Figure 1 illustrates parts of this fan. Upon removing fan from the package, checks to make sure all parts are complete.
1. Attach fan base to fan body using 4 screws included.
2. Place fan base on firm stable surface such as a table or counter top.
3. Discard the plastic sleeve from the shaft.
4. Secure the rear grille to the motor housing with the plastic nut. The handle should be at the top. Turn clockwise
to tighten.
5. Slide the blade onto the shaft pin, pushing it on until it is firmly in place.
6. Test blade operation by rotating it with your hand. There should be no friction with the other parts. If blade does
not rotate freely, repeat steps 4-5.
7. Place blade cap on shaft pin and turn counterclockwise until tight.
8. Ensure latches on either side of the rear grille are open. Place front and rear grille together and close the side
latches. If they do not fit securely together, repeat the procedure.
Airworks
12MDWA

GETTING TO KNOW YOUR FAN

ASSEMBLY

Retaining
Pin
4