Rear Panel - Traynor TVM 10 Owner's Manual

Phones Jack
Connect standard stereo headphones to this jack using
a ¼-inch stereo plug.
Note: the internal speaker is disconnected when the
Phones jack is in use.
Power/Battery Status Light
When the power switch is on and the battery is
fully charged, this LED illuminates yellow. The LED
illuminates red when the battery needs recharging.
Power Switch
Use this switch to turn the amplifier on and off. Switch
it OFF when charging the battery.

Rear Panel

DC Charger Connector
Connect the 15 VDC charger to the amp here to
recharge the battery (power switch off), then plug
the charger into an AC outlet. When fully charged,
the battery should provide approximately 10 hours of
amplifier use.
Speaker Configuration - (size / Power)
Input Channels
Channel 1 - inputs
Channel 2 - inputs
Aux inputs
Master Controls
LED Indicators
Headphone Jack
Other Features
Dimensions (DWH, inches)
Dimensions (DWH, cm)
Weight (lbs / kg)
NOTES:
1. The internal battery should be replaced by
authorized service technicians only!
2. For best performance, ensure that the TVM10 is
switched off while the DC charger is connected. The
TVM10's battery charging system is not designed as
an AC power source. Operate on battery power only.
3. The TVM10's battery is lead-acid based and should
never be fully drained. If the TVM10 is in storage it
is recommend to recharge the battery at least every
1 or 2 months.
Charger LED
This LED illuminates when the amp is being
charged. Once the battery is fully charged, this LED
will dim and turn off. The battery requires a minimum
of 24-hours to be recharged properly.
Specifications
Combo
Type
6-inch + tweeter / 15 Watts
2
Combi (1/4-inch + XLR female)
1/4-inch
2x RCA
Bass, Low-Mid, Hi-Mid, Treble
Power
Yes
Rechargable battery (usage with full charge, 10-hours)
Input of charger: 120V 600mA
Output of charger: 15V 1500mA
10.25 x 13.75 x 11.75
260 x 345 x 300
25 / 11.32
2