Zanussi FE 1014 N User Manual page 23

Problem
• Spinning starts late or the
laundry is not spun enough:
• The machine makes an unusual
noise
• No water is visible in the drum
If you are unable to identify or solve the problem,
contact our service centre. Before telephoning,
make a note of the model, serial number and
purchase date of your machine: the Service Centre
will require this information.
Possible cause
• The electronic unbalance detection device has cut
in because the laundry is not evenly distributed in
the drum. The laundry is redistributed by reverse
rotation of the drum. This may happen several
times before the unbalance disappears and
normal spinning can resume. If, after few minutes,
the laundry is still not evenly distributed in the
drum, the machine will spin at a lower speed or
will not spin. If at the end of the programme the
laundry is not spun enough, redistribute the load
manually and select the spin programme.
• The machine is fitted with a type of motor which
makes an unusual noise compared with other
traditional motors. This new motor ensures a
softer start and more even distribution of the
laundry in the drum when spinning, as well as
increased stability of the machine.
• Machines based on modern technology operate
very economically using very little water without
affecting performance.
Mod. ..........
Prod. No. ...........
Ser. No. .........
P0042
23