Table of Contents Introduction Features Package Contents Software Installation Federal Communications Commission (FCC) Statement CE Statement Limited Warranty Contact...
Introduction The ExpressCard Host allows you to upgrade your Notebook computer with up to two SATA II Channels. The board provides a 2.5Gbps ExpressCard interface on the host side, and dual fully compliant SATA II 3Gbps ports on the device side to access Serial ATA mobile external and internal storage devices such as: hard drives, ZIP drives, CD-ROMs, CD-RWs and DVD-ROM drives.
Features • External SATA II (eSATA) Connector • 48 bits LBA can Break Capacity-Limit to Support HDD larger than 137GB • Supports 1-lane 2.5Gbps ExpressCard/34 • Hot-plug capability • Supports SATA II transfer rate of 3.0Gbps • Fully compliant with Serial ATA 1.0 specifi cations •...
Software Installation Windows XP Installation 1. Insert the SATA Card into an available slot. Connect the serial ATA cable(s) between the SATA port and serial ATA device(s). 2. Windows will display the ‘Found New Hardware Wizard’. A new ‘Mass Storage controller’...
Page 8
5. Select “Search for the best driver in these locations”, and check “Include this location in the search:” Be sure to uncheck the other available boxes. 6. Type the appreciate media drive letter and select the “Browse” option. 7. Specify a location [CD Drive Let- ter]:\SATA Express_2Port \Sil3132 \ WinXP_2000_2003_NT, and click OPEN then select OK.
Page 9
Verify Windows XP Installation 1. Right click on the ‘My Computer’ icon, select ‘Properties’, left click on the ‘Hardware’ tab, and select the ‘Device Manager’ button. 2. Double click on ‘SCSI and RAID Controllers’, If there is no yellow ‘! ‘ or ‘ ? ‘ in front of ‘Silicon Image SiI 3132 SATALink Controller’, the driver is functioning properly.
Federal Communications Commission (FCC) Statement Federal Communications Commission (FCC) Statement 15.21 You are cautioned that changes or modifi cations not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. 15.105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules.
Page 11
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: 1.
CE Statement CE Statement This device has been tested and found to comply with the requirements set up in the council directive on the approximation of the law of member states relating to EMC Directive 89/336/EEC, Low Voltage Directive 73/23/EEC and R&TTE Directive 99/5/EC.
The manufacturer, IOGEAR, makes NO warranty or representation, whether express or implied, regarding the contents, use or suitability of this software, disk or documentation. IOGEAR specifi cally disclaims any and all warranties regarding the quality and performance of this software, disk or documentation including, but not limited to the implied warranty of merchantability and implied warranty of fi...
Need help?
Do you have a question about the GPS702e3W6 and is the answer not in the manual?
Questions and answers