Procedure 5 - Upholstery/Positioning Strap; Replacing Seat Upholstery; Replacing Seat Positioning Strap - Invacare Wheelchair Owner's Operator And Maintenance Manual

UPHOLSTERY/POSITIONING STRAP
This Procedure Includes the Following:

Replacing Seat Upholstery

Replacing Seat Positioning Strap

WARNING
After ANY adjustments, repair or service and BE-
FORE use, make sure all attaching hardware is
tightened securely - otherwise injury or damage
may result.
REPLACING SEAT UPHOLSTERY
(FIGURE 1)
1. Remove the eight (8) phillips screws and washers that
secure the existing seat upholstery to the crossbraces.
2. Remove existing seat upholstery from the crossbraces.
3. Line up mounting holes in new seat upholstery with
mounting holes in the crossbraces.
4. Securely tighten with existing phillips screws and wash-
ers.
NOTE: Clean upholstery with warm DAMP cloth and mild
detergent to remove superficial soil.
WARNING
Laundering or moisture will reduce flame re-
tardation of the upholstery.
Phillips
Screws
FIGURE 1 - REPLACING SEAT UPHOLSTERY
REPLACING SEAT POSITIONING
STRAP (FIGURE 2)
1. If necessary, remove the seat cushion from the seat
2. Remove the two (2) rear phillips screws and washers
3. Remove the two (2) halves of the seat positioning
4. Position the two (2) new seat positioning strap halves
5. Reinstall the rear phillips screws and washers that
NOTE: Washer is positioned on top of seat upholstery.
6. If necessary, reinstall the seat cushion onto the seat
Washer
Seat Positioning
Washers
FIGURE 2 - REPLACING SEAT POSITIONING STRAP
Seat Upholstery
19
upholstery.
that secure the seat upholstery and seat positioning
strap to the crossbraces.
strap from the crossbraces.
between the seat upholstery and the crossbraces.
secure the seat upholstery and seat positioning strap
to the crossbraces.
upholstery.
Rear Phillips Screw
Strap
Crossbrace
PROCEDURE 5
U
P
H
O
L
S
T
E
R
Y
Seat Upholstery
P
O
S
I
T
I
O
N
I
N
G
S
T
R
A
P