Invacare User guide User Manual page 59

Electrical Adjustment of Seat Angle
TM
If your Spectra Blitz power chair is fitted with an electrical seat angle adjustment refer to section
12 Controls and Operating your Powerchair or see the seperate control system user guide
1. Seat angle adjustment is made by operating the control system.
Manual Adjustment of Seat Angle
If your Spectra Blitz power chair is fitted with a manual seat angle adjustment refer
to the following to set the required seat angle:
1. Remove the M10 nut and bolt at the base of the assembly
2. Rotate the female (lower) assembly clockwise to increase the seat angle or
counter clockwise to decrease the seat angle
3. Once the desired seat angle is achieved replace the M10 nut and bolt, and
tighten the lock nut against the female assembly
WARNING
• This adjustment should only be performed when the wheelchair is
unoccupied .
Lock Nut
Collar
59