Connecting And Charging - Oral-B Professional Black 7000 Smart Manual

English
Important Information
• Your Oral-B Black 7000 uses an interactive
wireless display. To avoid electromagnetic
interference and/or compatibility conflicts,
deactivate the radio transmission before using
it in restricted surroundings, such as aircrafts or
specially marked areas in hospitals. Deactivate
radio transmission by simultaneously pressing
the on/off and mode button for 3 seconds until
the radio transmission display (f) goes off.
Follow the same procedure to reactivate
transmission again.
• Persons with pacemakers should always keep
the toothbrush more than six inches (15 centi-
meters) from the pacemaker while turned on.
Anytime you suspect interference is taking
place, deactivate the radio transmission of your
toothbrush.
Description
a Brush head
b Pressure sensor light
c On/off button
d Brushing mode button
e Handle
f Radio transmission display
g Charge indicator
h Charging unit (basic charger and brush head
compartment with protective cover)
i SmartGuide
j SmartGuide holder
k Wall mount
l Adhesive ring
m Travel case
n Travel charger pouch

Connecting and charging

Your toothbrush has a waterproof handle, is electri-
cally safe and designed for use in the bathroom.
• Plug the charger into an electrical outlet. For
voltage specifications refer to the bottom of the
charging unit.
• The flashing blue lights indicate that the toothbrush
is charging (picture 1, page 5); once it is fully
charged, the lights turn off. A full charge can take
up to 24 hours and enables up to ten days of
regular brushing (twice a day, 2 minutes).
Note: After deep discharge, the blue lights might
not flash immediately; it can take up to 10–15
minutes.
• If the rechargeable battery is low the red charge
indicator light is flashing for some seconds when
turning your toothbrush on/off.
If the rechargeable battery is empty the motor will
stop; it will need a 40-minute charge before you
can use it for a 2-minute brushing.
• For everyday use, the toothbrush handle can be
stored on the charging unit to maintain it at full
power. Overcharging is impossible. To maintain
the maximum capacity of the rechargeable battery,
unplug the charging unit and fully discharge the
handle with regular use at least every 6 months.
SmartGuide adjustments
The SmartGuide (i) comes with a demonstration
mode activated. Deactivate this mode by removing
the battery compartment cover in the back (picture A,
page 4) and push the «set» or «h/min» button.
A flashing «12:00» indicates that you can now adjust
the clock time.
If you prefer not to use the clock feature, the flashing
«12:00» will disappear automatically after 24h.
Note: If the SmartGuide display is blank before first
use (no active demonstration mode) the batteries will
need to be replaced before continuing. Replacement
batteries are supplied.
Clock Time
Press and hold the «set» button until «12h» is
displayed. By briefly pressing the «h/min» button,
you can toggle between «12h» or «24h» daytime
format. Push «set» to confirm your choice. Then
the hour digit starts flashing. Press the «h/min»
button until the right hour appears and confirm with
«set». Proceed same way to set both minute digits
(picture B, page 4).
7