Advertisement
POLYGLASS VB
User Manual
o
Woofer
01--------<0
Cables and connections
For best results with your Polyglass speakers, we recommend you include the use of Focal cables.
Alternatively, other high quality cable can be used, if sufficient section thickness is available
(minimum thickness
=
1mm
2
).
This is particularly important for long lengths of cable to
ensure a strong efficient signal is maintained. Always ensure the polarity is respected,
(+
is
connected to
+)
and (- is connected to -). Maintain correct connections, from principal source
radiol amplifier (left
I
right Ifront and rear), and crossover to speakers (tweeter to tweeter), (mid
to mid), (woofer to woofer), is always observed. If the woofer is located at the bottom on the
door, connect the woofer directly on the amplifier in order to have more dynamic midrange.
Woofer
~
•
.-----~g
Right Output
Input
~
Tweeter
0
j[j
~-~~~~~---=g~
gr----
OU
[ 0((-= =-))0]
.
0 0 0 0 0
.
Fitting the tweeter
There are two mounting possibilities available: surface or flush mount. The tweeter arrives
supplied in its flush-mounting pod. Very carefully, remove the grille, by gently prizing it off
(using a paper clip will help).
Surface mounting: choose the angle that best suits your installation (10° or 30°) and mount
the pod firmly using the screws supplied. Feed the wire through the hole in the pod and refit
the 1weeter and grille in place.
' 9 ::&"' - -------
"HI. - -
'9~
Flush mounting: cut a neat 40mm diameter@l
Unlocking tool
~
hole in the panel where you want to place the
Th
. h h i '
.
hid
000
00
- - - - -
Tweeter ----
000
00
tweeter.
en Wit
t e meta mounting striP
e
____
from behind (ensuring the ends are pointing
Pod
towards the hole), insert the screw through the
~
~
flush-mount pod from the front and tighten the two
~
~
parts together. Feed the wire through the hole in
Mounting strip
the pod and re-fit the tweeter and grille in place.
Advertisement
