Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi CH 6029 GR
Summary of Contents for Zanussi CH 6029 GR
- Page 1 INSTRUCTION BOOKLET INTEGRATED COOKER HOOD CH 6029 GR...
-
Page 2: For The User
If you require guidance in the use of the appliance or require further information on Zanussi Products, please contact our Customer Care Department. For general enquiries concerning your Zanussi appliance or for further information, visit our website at http:\\www.zanussi.co.uk... -
Page 3: Important Safety Information
• If the room where the hood is to be used cause injury or more serious malfunction. contains a fuel burning appliance such as a Refer to your local Zanussi Service Force central heating boiler then its flue must be of Centre. Always insist on genuine spare the room sealed or balanced flue type. -
Page 4: Your Appliance
YOUR APPLIANCE OPERATING INSTRUCTIONS The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. To obtain the best performance it is advisable to switch on the hood a few minutes before you start cooking and leave it running for approximately 15 minutes after finishing. - Page 5 The appliance can be installed to recirculate or extract contaminated air. The cooker hood is more effective when used in the extraction mode. Extraction In the extraction mode the contaminated air enters the cooker hood, passes through the grease filter and out through the ducting to the atmosphere.
-
Page 6: Maintenance And Cleaning
MAINTENANCE AND CLEANING Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply. The cooker hood must be kept clean, as a build up of grease or fat can be a fire hazard The external surfaces of the hood should be cleaned regularly. -
Page 7: Grease Filter
Synthetic Grease Filter The grease filter has saturation indicators, which are small squares made from a series of dots. When the white paper inside the squares becomes saturated with grease the coloured dots start to run and spread across the paper, indicating that the filter has reached saturation point and must be replaced. -
Page 8: Something Not Working
If you require an engineer or wish to purchase spare For general assistance with your appliance or for parts contact your local Service Force Centre by information on Zanussi products please contact our telephoning: Customer Care Department. Customer Care Department,... -
Page 9: Peace Of Mind For Twenty Four Months
STANDARD GUARANTEE CONDITIONS We, Zanussi, undertake that if within twenty four months of the date of the purchase this Zanussi built-in appliance or any part there of is proved to be defective by reason only of faulty workmanship or materials, the company will, at our option repair or replace the same FREE OF ANY CHARGE for labour, materials or carriage on condition that: •... -
Page 10: Installation Instructions
INSTALLATION INSTRUCTIONS It is dangerous to alter the specifications or attempt to modify this product in any way. Technical Information DIMENSIONS HEIGHT: 20.00cm WIDTH 52.20cm DEPTH 28.50cm DUCTING OUTLET: 120mm WEIGHT GROSS: 4.8kg NET: 5.8kg ELECTRICAL SUPPLY: Voltage (50Hz) 220-240 V POWER CONSUMPTION: 175 W FAN MOTOR:... -
Page 11: Installing The Cooker Hood
INSTALLING THE COOKER HOOD Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown. All installations must comply with the local authorities requirements for the discharge of exhaust air. Incorrect installation may affect the safety of this cooker hood. - Page 12 A minimum clearance height of 650mm ”) is required when installed above a built-in electric hob, or 700mm (27 ”) when installed above a built-in gas hob. A minimum clearance height of 685mm (27”) is required when installed above a slot-in electric cooker, or 787mm (30 ”) when installed above a slot-in gas cooker.
- Page 13 The hood is fixed using the holes located in the rim around the base of the casing visible when the inlet grille is in the open position. Support the grille panel with one hand and draw down on the two grey handles (A) which are located on each side of the grille with the other hand.
- Page 14 Ducting The ducting used must be fire retardant 125mm (5”) in diameter. If possible duct through the wall at the rear of the canopy or wall cabinet. For the best performance use the shortest possible duct run and the minimum number of bends. Where flexible ducting is fitted it should not be turned through very tight bends as this may impair the performance of the hood.
- Page 20 © Electrolux Household Appliances Limited 2000 4329077 02 - 010911...