Serviceman; Before Calling The - Toshiba AW-SD120SM Owner's Manual

BEFORE CALLING THE SERVICEMAN
The following are not malfunction.
Course
During Water flows out of the drainage hose
operation
when the machine is used at first time.
Washing-spinning tub and pulsator do
not run immediately.
Washing
pulsator revolves before and during
flowing water.
Flowing water stops during washing.
Beeper rings and detergent is
discharged.
Water level is not suitable for the actual
weight of clothes.
Rinsing
The water for final rinsing looks
somewhat turbid.
Flowing water is not available after the
start of rinsing.
Overflow rinse mode changes into
soaking & rinsing mode without any
button pushing.
Spinning
Water is not removed completely after
spinning.
Spinning does not start after rinsing.
The power cannot be turned on.
Spinning mode changes into soaking &
rinsing modes without any button
pushing.
The washing machine is longer than
usual.
32
Status
• Water remains during the performance test in factory.
• The clutch is switched.
• Before flowing water → Check the weight of clothes.
• During flowing water → Dissolve detergent with high-efficiency.
• If the indicator of CONDENSED BUBBLE is lighted, water will be
flowed at a low level during washing.
• If water level reduces during washing, water will be automatically
added.
• When children-proof lock is set, this event will occur if the cover is
opened.
• During CONDENSED BUBBLE course, water will be flowed at
the same time of washing if needed. Therefore, the water level
looks lower at the beginning. When the display of WATER LEVEL
is flashing, it means flowing water is not yet finished.
• Water level depends on the weight of clothes. Many chemical fiber
clothes or adding of soaked clothes will be regarded as heavy
articles by the sensor. If the water level is not suitable, please
adjust it according to the actual weight of clothes. If the water level
always appears slightly less or more than the suitable amount, you
may use the automatic fine setting.
• Zeolite is not the major composite of the detergent used. Under
such situation, please increase rinsing frequency or switch
overflow rinse into soaking & rinsing.
• When there is no water in the washing-spinning tub, flowing water
is not available from spinning course to remove the water or
detergent contained in clothes. Water will be re-flowed after
spinning. (If there is water in the tub, this situation will occur
from draining.)
• When the water level is lower than 60 liters, overflow rinse will
automatically switch into static rinsing.
• During spinning before overflow rinse, if the center gravity of
clothes shifts, soaking & rinsing will be enabled automatically.
• Spinning performance changes according to the type of clothes.
• If you need further spinning, please run "SUPER SPIN DRY"
function for 30 minutes or 60 minutes.
• When the operation is held for 30 minutes or more, spinning
won't restart until the drainage valve is open. Also, a certain
length of time will be reserved for safety reason to restart the
operation just after holding. When the power is turned off during
spinning, it cannot be turned on again until rotation of washing-
spinning tub stops.
• During spinning, if the center gravity of clothes shifts, soaking &
rinsing will be enabled automatically. Spinning will restart after
overflow.
This situation will also occur when the drainage hose is dirty due
to powder detergent etc.
If the situation is not corrected after two cycles of the above
operations, "E31" or "E32" will be displayed, and a warning sound
will be heard at the same time.
Check