ASROCK Z97 Anniversary User Manual page 25

1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis must
2. If you use an AC'97 audio panel, please install it to the front panel audio header by
Chassis Speaker Header
(4-pin SPEAKER1)
(see p.6, No. 20)
Chassis and Power Fan
Connectors
(4-pin CHA_FAN1)
(see p.6, No. 14)
(4-pin CHA_FAN2)
(see p.6, No. 7)
(3-pin PWR_FAN1)
(see p.6, No. 1)
CPU Fan Connectors
(4-pin CPU_FAN1)
(see p.6, No. 24)
(3-pin CPU_FAN2)
(see p.6, No. 25)
20
support HDA to function correctly. Please follow the instructions in our manual and
chassis manual to install your system.
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to
connect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
DUMMY
1
+5V
FAN_SPEED
FAN_SPEED_CONTROL
1
2
3
4
FAN_SPEED
GND
1
2
3
4
Please connect the chassis
SPEAKER
speaker to this header.
DUMMY
Please connect fan cables
to the fan connectors and
GND
+12V match the black wire to
the ground pin.
GND
+12V
FAN_SPEED
FAN_SPEED_CONTROL
+12V
This motherboard pro-
GND
vides a 4-Pin CPU fan
+12V
FAN_SPEED
(Quiet Fan) connector.
FAN_SPEED_CONTROL
If you plan to connect a
3-Pin CPU fan, please
GND
FAN_VOLTAGE
connect it to Pin 1-3.
FAN_SPEED