Table of Contents
Advertisement
Maintenance & Safety
Tape deck maintenance
To ensure quality recording and playback of
the tape deck, clean parts A, B and C as
shown, once a month. Use a cotton bud
slightly moistened with alcohol or a special
head cleaning fluid to clean the deck.
1 Open the cassette holder by pressing 9/.
2 Press 1 and clean the roller C.
3 Press ; and clean the heads A, and the cap-
stan B.
4 After cleaning, press 9/.
➜
Cleaning of the heads can also be done by
playing a cleaning cassette through once.
C
B
A
A
Safety information
•
Place the set on a flat, hard and stable surface
so that the system does not tilt.
•
Do not expose the set, batteries to humidity,
rain, sand or excessive heat caused by heating
equipment or direct sunlight.
•
The apparatus shall not be exposed to drip-
ping or splashing.
•
the MAINS plug or an appliance coupler is
used as the disconnet device, the disconnet
device shall remain readily operable.
•
Adequate ventilation with a minimum gap of
15cm (6 inches) between the ventilation
holes and surrounding surfaces is necessary
to prevent heat build-up.
•
Do not cover the ventilation openings with
items such as newspapers, table-cloths, cur-
tains, etc.
•
No objects filled with liquids, such as vases,
shall be placed on the apparatus.
•
No naked flame sources, such as lighted can-
dles, should be placed on the apparatus.
•
The mechanical parts of the set contain self-
lubricating bearings and must not be oiled or
lubricated.
•
To clean the set, use a dry cloth. Do not use
any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may
harm the housing.
Advertisement
Table of Contents
