Door Reversal - Electrolux ER 6822 D Instruction Book

Door reversal

1. Disconnect from the electricity supply;
2. Remove all loose item, including food, store food
in a cool place;
3. Gently lay the fridge/freezer on its back with the
top held away from the floor by 5-8 cm (2-3
inches) of packing;
4. Remove the feet (2-3).
5. Unscrew the bottom hinge (1).
6. Slide out the lower door from middle hinge (H)
and remove the latter.
7. Slide out the upper door from pin (G), unscrew
the latter and then screw it down into the hinge
provided on the opposite side, after having
removed the small plugs which should then be
fitted on the opposite side.
8. Refit the upper door and the middle hinge on the
opposite side.
9. Screw down the bottom hinge (1) on the opposite
side by using the screws previously removed.
10.Refit the feet (2-3) on the opposite side.
11.The doors can be aligned by adjusting the middle
hinge.
12.The middle hinge can be adjusted horizontally,
with the help of a tool, after having slackened the
two screws.
Attention
After completion of the door reversing operation,
check that the door gasket adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that
case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part
involved with a normal hairdryer on a low setting.
16
H
D419
3
D715 PIED/M
G
1
2