Section 6-Troubleshooting - Invacare IH6300ADH Owner's Operator And Maintenance Manual

SECTION 6—TROUBLESHOOTING
SYSTEM/OPERATION
Adjustable Height
Model IH6300ADH
Hydromassage System
Disinfecting System
Tub Operation
NOTE: If problems are not remedied by the suggested means above, contact an Invacare Dealer.
Part No 1096926
SYMPTOMS
Tub will not raise Glide pads not greased
or lower
Bad electrical connections
Actuator overloaded
Actuator burned out
Obstacle in tub path
No electrical power to tub Check and reset breaker or
System will not start No electrical power to tub Check and reset breaker or
System not prepared
Switch hose disconnected
System is ineffective Water deposits in
whirlpool jets
Whirlpool jets closed
Aerator closed
Whirlpool intake clogged
No discharge from Whirlpool jets open
disinfectant wand
Whirlpool intake open
Hose kinked
Disinfectant siphon tube
kinked
Flow meter adjustment
knob turned off
No water flow Water supply turned off
Restricted water flow RADA valve. Refer to
RADA owner's manual.
31
SECTION 6—TROUBLESHOOTING
FAULTS
Grease glide pads.
Refer to Maintenance for
IH6300ADH Adjustable Height
ONLY Glide Pads on page 26.
Check electrical connections at
the control box.
Wait 5 minutes and try adjusting
height again.
Contact an Invacare Dealer.
Inspect and remove obstacle.
GFCI.
GFCI.
Be sure water level is above jets.
Check that inlet plug on tub is
depressed.
Reconnect hose to switch and
motor.
Disassemble and clean whirlpool
jets.
Open whirlpool jets.
Open aerator.
Inspect intake and remove
obstruction.
Close whirlpool jets.
Close whirlpool intake.
Inspect hose and unkink.
Inspect siphon tube and unkink.
Turn flow meter adjustment knob
to proper setting.
Turn on water supply.
Inspect and clean RADA valve.
SOLUTION
Supine Bath Tub