Operating Sequence - Zanussi ZDI 6895 QX Instruction Book

Operating sequence

1. Check the filters
Ensure they are clean and properly positioned (see
"Maintenance and cleaning").
2. Press the On/Off push button
The display will show the last selected programme and
the corresponding phase indicator lights will illuminate.
If the door is open also the "open door" indicator light
will illuminate.
3. Check that there is rinse aid and salt
The corresponding indicator lights will illuminate if
refilling is necessary.
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the saucepans,
plates and cutlery in it.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5. Ensure that the spray arms can
rotate freely
6. Measure out detergent
Add the required amount of detergent into the dispenser.
Important!
If you select the half load option remember to reduce the
quantity of detergent.
Close the detergent dispenser lid.
7. The setting of the programme can
be done both with opened or closed
door
Opened door: select the programme and if necessary
the options (drying options, half load, delay start).
The START push button can be pressed before the
closure of the door (in this case the phase indicator
lights for that programme will turn off, except for the
indicator light of the first phase of the programme that
will flash continuously until the closure of the door).
Close the door and the programme will start
automatically.
Opened door: select the programme and if necessary
the options (drying options, half load, delay start).
Close the door and press the START push button, the
programme will start automatically.
Closed door: select the programme and if necessary
the options (drying options, half load, delay start).
The start of the programme will only occur only after
having pressed the START push button.
8a. Setting and starting the programme
without "delay start"
Press the "SELECTION" push button until the required
programme number appears in the digital display.
Select a drying option and/or half load (if desired).
Press the START push button, an audible signal advises
you that the programme has started.
The display will show the running time of the programme
and the indicator lights of the phases will turn off except
for the indicator light of the current phase.
The time in the digital display will start to decrease from
minute to minute.
Pressing the "SELECTION" push button while the
programme is running will display the number of the
current programme.
If the door is opened during the run of the programme
the current phase will be interrupted and the digital
display will show the number of the programme. The
indicator light of the interrupted phase will start to flash
and the indicator light "open door" will illuminate.
Once the door is closed the programme will start from
the point where it was interrupted.
8b. Setting and starting the programme
with "delay start"
Once a programme and required options (see point 8a)
have been selected to use DELAY proceed as follows:
Press the DELAY push button. The digital display will
show "h 0". Press the button again to select the number
of hours by which you wish to delay the programme start
(up to a maximum of 12 hours).
The delay start will not modify the settings made
previously .
To set the time setting to zero press the DELAY push
button until "h 0" appears in the digital display.
Press the START push button.
The digital display shows the delay time required before
the start of the programme that will decrease from hour
in hour.
The start of the countdown will be confirmed by the
flashing "h" in the digital display.
The phase indicator lights will turn off, only the indicator
lights of the options (drying and/or half load), if selected,
will remain on.
Once the delayed time has elapsed the programme will
start automatically.
If you desire to cancel a delay start in progress follow
the instructions given in the following chapter (point 9).
12