Advertisement
WT-368 CDMA Phone
You should write a number for your FWP before you using all of the functions on your
FWP. You can operate it like this as below:
1. Open the AnyDataESN Software
2. Connect the computer with the data cable
i)
Turn on the power supply of wireless phone. You can see the power supply
switch at the back of the wireless phone.
ii) Connect the phone and the computer with the data cable.
Notice: Make sure that the handset is out of the phone during you write the
number for your phone. Or you cannot write the number successful
3. After 10 or 15 seconds, you can open the Software and you will see this picture as
below in Picture 1.0
4. After you connect the phone and your computer with the cable, please press the
WT-368 – USER MANUAL – Rev.1 – Technical Support:
Picture 1.0
COPYRIGHT ©2008 WITURA CORPORATION SDN BHD
technical@witura.com
8
Advertisement
