Troubleshooting - Pro Audio MC 9010 iP User Manual

TROUBLESHOOTING

If a fault occurs, first check the points listed below before taking the set for repair. Do not open the set as
there is a risk of electric shock.
Problem
No sound / power
Display does not function properly / No
reaction to operation of any of the controls
The CD skips tracks
No disc indication
CD Playback does not work
USB / Memory card failure
If this product should be defective, despite our high standard quality control,
The hotline is available Monday through Friday from 10am to 6pm at this number:
In case your product needs to be sent to our service centre, please use the provided return sticker.
If the return sticker is missing, please contact the service & support hotline
Cause
Volume not adjusted
Power cord not securely connected
Electrostatic discharge
CD damaged or dirty
Program is active
No CD inserted
CD badly scratched or dirty
Laser lens has steamed up
CD-R is blank or the disc is not finalized
CD badly scratched or dirty
Laser lens steamed up
USB / Memoy Card connecting error
USB / Memory Card does not contain playable
files
please contact the service & support hotline.
0180 5 - 22 17 84
Solution
Adjust the Volume
Connect the AC cord properly
Switch off and unplug the set. Reconnect after a
few seconds
Replace or clean CD
Quit program mode
Insert a CD, CD-R or CD-RW
Replace or clean CD
Wait until lens has cleared
Use a finalized CD-R
Replace or clean CD
Wait until lens has adjusted to room temperature
Unplug and reinsert memory card or USB stick
Use a USB / Memory Card containing MP3 or
WMA files