System Reset Procedure - Yamaha PortaTone PSR-1700 Owner's Manual

Appendix
Digital Sampling-related Error Messages (PSR-2700)
No Bank
No Wave Data
Protected Voice
Same Note
Wave Ram Full
Wrong Disk
Other Error Messages
IllegalOperation
Memory Full

System Reset Procedure

All internal memory settings are retained in memory even when the power switch is turned OFF as long as a
good set of backup batteries is present or the AC plug is connected. You can, however, restore the factory default
settings by following the procedures outlined below.
ON/ OFF
POWER
82
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |
The maximum of 255 "banks" of data has been exceeded (one pad contains one "bank").
Clear all unnecessary pads and voice data before attempting to sample more data.
You have attempted to map or tune a pad or entering an original voice name that contains
no sampled voice data.
You have attempted to clear, record, or edit a pre-programmed disk voice file. In some
cases pre-programmed sampled voices ("Protected Voices") can only be loaded.
You have attempted to map a pad to key to which another pad is already mapped. Map
either pad to a different key.
The wave RAM memory is full and can accept no more sampled voice data (the wave RAM
is 1,020 kilobytes). Clear all unnecessary pads and voice data before attempting to sample
more data.
You have inserted the wrong disk or a disk that does not contain the required data. Large
sampled voice data files may span more than one disk, and these must be inserted in the
correct order when loading the file. Check the disk number and try again.
You have pressed a button that can not be used in the current mode. Read the instructions
for the function you are using carefully, and use appropriate function button.
The PSR-1700/2700 recording memory has become full while recording Song Memory,
Custom Accompaniment, or Multi Pad data. Save data you want to keep to disk and clear
all unnecessary data from memory to make more room.
Z
Press the [POWER] switch to turn the PSR-1700/PSR-2700 power OFF.
– +
X
Turn the power back ON while holding both the [+] and [–] buttons.
RESET
"Backup RAM Clear" will appear on the LCD display panel while the
data is being reset.
IMPORTANT
• Executing the System Reset function will erase all internal
memory settings