Starting And Stopping; Cutting Height Adjustment; Thermal Cut-Out - Flymo Speedi-Mo Original Instructions Manual

J
Cutting Height Adjustment (J) & (K)
• Height of cut is adjusted by raising or lowering the
Front and Rear Wheels.
• There are five heights of cut on this product.
• NOTE
A medium height of cut is recommended for most
lawns.
The quality of your lawn will suffer and collection will
be poor if you cut too low.
L
1
N
1. Start mowing the edge of the lawn nearest to the power point so the cable is laid out on the lawn you have already
cut.
2. Mow twice a week during the growing season, your lawn will suffer if more than a third of its length is cut at one time
and this may also result in poor collection.
Do Not Overload Your Mower
Mowing long thick grass may cause the motor speed to drop, you will hear a change in the motor sound. If the motor
speed drops you may overload your lawnmower which may cause damage. When mowing in long thick grass a first
cut with the cutting height set higher will help reduce the load. See Cutting Height Adjustment.
The Motor is protected by a Thermal Cut-Out which is activated when the blade becomes jammed or if the motor is
overloaded. When this occurs, stop and remove the plug from the power supply. The Thermal Cut-Out will only reset
when the start/stop lever is released. Clear any obstruction and wait for a few minutes for the Thermal Cut-Out to reset
before continuing to use the mower.

Cutting Height Adjustment

2cm
4cm
6cm

Starting and Stopping

M
How to Mow

Thermal Cut-Out

K
HEIGHT OF CUT
Low
Low to Medium
Medium
Medium to High
High
To Start your Lawnmower
1. Connect plug to mains and switch on.
The switchbox is provided with a lock-off button (L1) to
prevent accidental starting.
1. Press and hold the lock-off button (L) on the switch-
box, then squeeze one of the Start/Stop levers towards
the upper handle (M).
2. Continue to squeeze the start/stop lever towards the
upper handle and release the lock-off button (N).
3. Lower the lawnmower to its proper operating position
and commence mowing.
• NOTE - There are two start/stop levers fitted. Either
one can be used for starting the lawnmower.
• IMPORTANT - Do not use the start/stop levers intermit-
tently
To Stop your Lawnmower
1. Release the pressure on the Start/Stop lever.
WHEELS POSITION
Front position 2cm
Rear position 2cm
Front position 2cm
Rear position 4cm
Front position 4cm
Rear position 4cm
Front position 4cm
Rear position 6cm
Front position 6cm
Rear position 6cm