Floor Protection; Faceplate Assembly; Faceplate Installation - Vermont Castings WR2500X02 Owner's Manual

6
6
2
5
1

floor Protection

This appliance must be installed in a masonry fireplace
enclosure built in accordance with
local building codes. Do not
InStALL In A fACtoRy BUILt
fIREPLACE SUCH AS A ZERo
CLEARAnCE.
Floor protector must extend to
cover area shown on the diagram
below.
When the floor covering the area
shown is concrete, no floor pro-
tector is required.
Carpeting and any other combus-
tible material shall not cover the
floor protector.
If a combustible surface is applied to the concrete floor,
a clearance must be maintained equivalent to the area
reserved for the floor protector. (Fig. 4)
If the area shown is a combustible floor or a combustible
floor covering, a 3/8" (10 mm) thick noncombustible mill-
board floor protector or durable equivalent must be in-
stalled. The pad must cover the area shown.
A grouted ceramic floor tile surface installed per local
building code is considered a durable equivalent.
30005129
6
6
4
2
5
*
1
1
1
1
*
1
3
Figure 3
Install Firebrick
Tip - Install Front (*) Fire Bricks First
ST1031
install firebrick
10/08
Face
Plate
8" (203 mm)
Figure 4
Floor Protector
*
1
1
*
1
3
Refer to Figure 5
1. Assemble top (#1) to sides (#2) using #8 x 1/2" Tek
screws (#9).
2. Attach the side right and left trims (#5,6) to sides (#2)
using #8 brass screws.
3. Attach top right and left trims (#3,4) together with the
articulating angles (#8).
4. Install corner brackets (#7) to top trim.
5. Attach top trim to face plate placing corner brack-
ets into side trim and tightening screws in the corner
brackets to secure.
1. Hook one end of spring (#10) into hole on stove top.
2. Hook the other end of the spring through the 1/8" (3
mm) hole in the faceplate top. (Fig. 6)
3. Slide the face plate against the masonry wall. notE:
Use the installation bulletin supplied with the face plate
as protection to prevent scratching the stove top.
Windsor High Efficiency Wood Insert
2
16" (406 mm) in the US
Door Side of 18" (457 mm) in Canada
Appliance
8" (203 mm)
Floor Protector

faceplate Assembly

face Plate Installation
ST1031
ST1023
5