Electrolux EFC60246 User Manual page 9

9 electrolux
Installation
Hood body installation
• Before attaching the hood body, tight-
en the two screws Vr located on the
hood body mounting points.
• Hook the hood body onto the screws
EN
12a.
• Fully tighten support screws 12a.
• Adjust screws Vr to level the hood
body
Connection in Ducting Version
When installing the ducting version, con-
nect the hood to the chimney using either
a flexible or rigid pipe ø 150 or 120 mm,
the choice of which is left to the installer.
To install a ø 150 pipe
• Fix the pipe in position using sufficient
pipe clamps (not supplied).
To install a ø 120 pipe
• To install a ø 120 mm air exhaust con-
nection, insert the reducer flange 9 on
the hood body outlet.
• Fix the pipe in position using sufficient
pipe clamps (not supplied).
• Remove any activated charcoal filters.
Connection in Recycling Version
• Insert the connection extension pieces
laterally 14.1 in connec-tion 15.
• Insert the Connector 15 into the
Support bracket 7.3 and fix it with a
screw.
• Make sure that the outlet of the exten-
sion pieces 14.1 is hori-zontally and
vertically aligned with the chimney out-
lets.
• Connect the air outlet connection 15
to the hood body outlet using either
a flexible or rigid pipe ø 150 mm, the
choice of which is left to the installer.
• Ensure that the activated charcoal fil-
ters have been inserted.
���
�����
�
����
���
��
�����
��
�����