Installing A Diversity Tuner Module (Urx-M2) - Sony UWP-V1 Operating Instructions Manual

While pushing the bottom of the belt
clip to make some space between the
belt clip and the tuner (1), align the
vertical parts of the belt clip with the
two vertical grooves on the shoe
mount adapter. Then, push the shoe
mount adapter in the direction of the
arrow (2). Push it fully until the
horizontal groove on the shoe mount
adapter holds the horizontal part of
the belt clip in place.
32 Attachment and Installation Procedures
To remove the shoe mount adapter
While pushing on the "PUSH" marking
on the shoe mount adapter (1),
disengage the horizontal part of the belt
clip from the horizontal groove on the
shoe mount adapter (2). Then, push
the shoe mount adapter in the direction
of the arrow (3).
Installing a diversity tuner
module (URX-M2)
Notes
• Before installing the diversity tuner
module (URX-M2), make sure the unit
into which the tuner module will be
installed is turned off. Do not install or
uninstall the tuner module while the unit
into which the tuner module will be
installed is turned on, as this may result in
malfunction of the tuner module or cause
noise.
• Do not put your fingers on the connectors
on the rear panel of the tuner module or
into the slot on the unit into which the
tuner module will be installed.
• Keep the tuner module away from static
electricity.