Polaris RZR 800 Owner's Manual page 119

Lights
Do not operate the vehicle at night or in low light conditions without
properly working headlights. Always make sure lights are adjusted
properly for best visibility.
Tip: If an LED headlamp has moisture or fogging inside, disconnect the wiring
harness from the headlamp(s) for a few days to allow the moisture to clear
out. Do not operate the vehicle at night or in low light conditions without
properly working headlights.
Poor lighting while driving can result in severe injury or death. Head-
light and taillight lenses become dirty during normal operation. Wash
the headlights frequently to maintain lighting quality.
Headlight Replacement (LED)
If an LED headlight becomes damaged or inoperable, the entire head-
light assembly must be replaced.
Tip: This type of headlight may have a short jumper cable between the wiring
harness and headlight assembly.
Headlight Lamp Replacement (Halogen)
Do not service the headlamps until
they've cooled sufficiently. When ser-
vicing a halogen lamp, don't touch the
lamp with bare fingers. Oil from your
skin leaves a residue, causing a hot
spot that will shorten the life of the
lamp.
1. Unplug the headlamp from the
wiring harness. Be sure to pull on
the connector, not on the wiring.
2. Turn the lamp counter-clockwise
to remove it.
3. Install the new lamp. Make sure
the tab on the lamp locates prop-
erly in the housing.
4. Reinstall the harness assembly
into the headlight assembly.
MAINTENANCE
Wiring Harness
117