Table of Contents
Advertisement
When the voltage of the battery is too low to operate the cart (below 10.8 volts) the
controller will cut power supply to the motors. In order to push the cart manually it is
necessary to move the wheels out by one notch on the drive axle. If you want to pull the
cart you will also need to change the wheels over to the other side of the cart. Securely
locate part A (the drive coupling) into part B (the wheel hub) for the normal drive
connection. For the freewheel mode depress the small latch on the outside of the wheel
catch mechanism - twist and pull the wheel (this moves the drive coupling out from the
hub) and locate it into the outer axle slot. The wheel should spin freely.
8 Use & Maintenance
Battery
1) Regularly check to see if the battery is damaged
2) Keep the battery surface clean, and check underneath the battery cover to make sure
that no dirt or water has attached to it.
3) Check the battery connections – underneath the small plastic covers – for any signs of
corrosion or bad connection.
4) Check that the wires from the battery cover are firmly fixed to the terminal posts.
5) After use always place the battery on charge – in warm dry conditions.
6) If the cart will be used again soon then you can leave the battery on charge until that time.
Always allow sufficient charging time to completely charge the battery – overnight or 6 to
8-hours should be sufficient.
Remote Control Golf Cart User Manual
Page 14 of 17
Advertisement
Table of Contents
