Advertisement

O O
M M
O O
M M
W W
N N
E E
R R
' '
S S
A A
N N
U U
A A
L L
W W
N N
E E
R R
' '
S S
A A
N N
U U
A A
L L
Dimension12
D D
O O
D D
E E
L L
E E
C C
T T
R R
O O
N N
I I
C C
S S
C C
O O
R R
P P
O O
R R
A A
T T
I I
O O
N N
D D
O O
D D
E E
L L
E E
C C
T T
R R
O O
N N
I I
C C
S S
C C
O O
R R
P P
O O
R R
A A
T T
I I
O O
N N

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Dimension12 and is the answer not in the manual?

Questions and answers

Summary of Contents for DOD Dimension12

  • Page 1 Dimension12...
  • Page 2: Safety Instructions

    WARNING C A U T I O N FOR YOUR PROTECTION, PLEASE READ THE FOLLOWING: R I S K O F E L E C T R I C S H O C K WATER AND MOISTURE: Appliance should not be used near water (e.g. near a D O N O T O P E N bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc).
  • Page 3 DOD Electronics Corporation President of DOD 8760 S. Sandy Parkway Sandy, Utah 84070, USA Effective: 11/24/98 European Contact: Your Local DOD Sales and Service Office or International Sales Office 3 Overlook Drive #4 Amherst, New Hampshire 03031, USA Tel (603) 672-4244...
  • Page 4: Front Panel Functions

    1. MIDI IN JACK Plug your MIDI controller in here (optional) 2. FOOTSWITCH INPUT Connect in the DOD FS3M here (optional) 3. A.C. ADAPTER INPUT Connect in the DOD PS750 in here 4. MONITOR OUTPUT Connect to mixer/pre-amp/amp input. 5. MAIN OUTPUT Connect to mixer/pre-amp/amp input.
  • Page 5 Dimension12 ROUTING/INSTALLATION Connect guitar out directly to the D12’s input, connect main output to the ampli- fiers input. Connect guitar out directly to the amplifier input, connect fx send to the D12’s input, and fx return to the D12’s main output.
  • Page 6 Dimension12 RECORD Select bank 1, 2, 3, or 4 (6 seconds each) or 1&2 or 3&4 (12 seconds each) Press record button (record LED will light indicating record is active). Press stop when done or wait until the full record time has fin- ished.
  • Page 7 Dimension12 STUTTER The Stutter Button (6) is used on the “fly”, that is while the sound sample is being played, the Stutter Button (6) is pressed at the point where you want the sample to “stutter”. When the Stutter Button (6) is pressed the first time, the Stutter LED lights indicating a stutter point has been selected.
  • Page 8: Delay Mode

    Dimension12 REVERSE MODE EDITING On the fly editing of the sound sample will operate in play mode in forward play only, no reverse mode editing is allowed. DELAY MODE This mode is accessed by pressing the Delay button (15). Turn the Data Wheel (7) to select desired delay time (0 ms-12 sec- onds).
  • Page 9: Recording With Effects

    Dimension12 EFFECT The effects parameter controls consist of an FX on/off button (17), a mix knob (21), an effects LFO speed control (18), a modulation depth control (19), and an effects feedback control (20). Effects may be used in both record and play back mode. The effect on/off is linked individually with each memory bank.
  • Page 10 Dimension12 MIDI The MIDI recieve channel is set to 10. Program change commands are: 1. bank 1 2. bank 2 3. bank 3 4. bank 4 5. bank 1&2 6. bank 3&4 7. stop 8. play 9. record 10. loop 11.
  • Page 11: Sample Banks

    1. The warranty registration card must be mailed within ten days after pur- chase date to validate the warranty of this DOD product. 2. DOD warrants this product (1 year parts, 1 year labor ), when used sole- ly within the U.S., to be free from defects in material and workmanship under normal use and service.
  • Page 12 8760 South Sandy Parkway Sandy, Utah 84070 International Distribution 3 Overlook Drive Unit 4 Amherst, New Hampshire 03031 U.S.A. FAX (603) 672-4246 DOD is a Registered Trademark of DOD Electronics © 1998 DOD Electronics Corporation Printed In U.S.A. 3/98 DOD 18-2230-A...

Table of Contents