Setting The Knife Height; Adjust The Table Extension Roller - King Canada KC-426C Instruction Manual

SETTING THE KNIFE HEIGHT

1. To obtain a knife projection of 1,5mm, place the knife setting gauge (E) on
the cutterhead with both guides resting firmly against the knife.
2. Loosen the assembly by turning the 7 screws (A) clockwise with an open
end wrench.
3. When the knife is pressed to the proper height by the guides on the gauge,
retighten the assembly by turning the screws counterclockwise. Make sure
all seven lock screws are tightened properly.
WARNING: The knife edge is very susceptible to chipping. Use caution when
handling the gauge near the knives to avoid damaging them.
WARNING: The assembly must be tightened securely to prevent accidents
during planing.
ADJUSTING THE TABLE EXTENSIONS
1. The table extensions are mounted at the front and rear ends of the main
table.
2. Raise the cutterhead assembly so that you can get a clear view and work
comfortably adjusting the extensions.
3. Place a straight edge across the main table and table extension to be
adjusted .
4. If the main table and table extension roller are not aligned, then adjust the
table extension by loosening nut (B) and turning screw (A) until the
extension table just touches the straight edge. adjust the right and left side
of the table extension in this way.
5. The roller has been factory set to align with the table extension, and
requires no further adjustment.
ADJUSTMENTS
Extension Table Roller
Knife Setting Gauge
FIGURE 6
FIGURE 7
Screw (A)
FIGURE 8
Nut (B)