Section 9 : Accessories Tray - X-Treme Jets F-16C Instruction Manual

Section 9:
Accessory tray installation
Items Required:
1. Fuselage
2. Retract valve
3. Brake valves
4. Door valve
5. Sequencers
6. Filler valves (2)
7. Air tanks (3)
8. JR Matchbox
The installation of the accessory tray is a personal thing. Many have vast experience and for them it will not be a
problem.
The lay out depends on what accessories you will be using. Some will use electronic valves and other will use 1
way and 2 way mechanical valves with servo's.
I have chosen Jetronic valves because of reliability. The use of a Gyro on rudder and steering is a good option.
A 9Ch receiver is minimum requirement for installation. Rudder (1) Steering (1)Elevator (2)Ailerons (2)
Brake(1)Retracts(1) Throttle(1)
Program the flight modes. Eg. Mode 1 for take off : Higher rates and less expo with sterring servo mixed to rudder
for the take off roll. Then select Mode to for general flying. Lower rates and higer expo. With gear retracted dis-
connect steering servo from rudder etc...
Mode 3 for landing... etc...
Use the manual supplied with radio to program your personal data.
Make sure good quality extension leads are used. Secure male and female plugs with safety clips or cable ties.
Run all servo wires well away from turbine wires.
9. Rx on/off switch
10. Receiver
11. Whip antenna
12. Ext leads
13. Powerbox or similar power supplies
14. Cable ties
15. Nicad / Lipo batteries
16. Marker & Ruler
P-19