AEG LAVAMAT TURBO 16830 Instruction Booklet page 39

Problem
The machine does not work
The machine does not fill
The machine fills then
empties immediately
The machine does not
empty and/or does not spin
Possible cause
The main electrical fuse or Replace the fuse.
the fuse in the plug has
blown.
The door is not properly
closed (E40).
The plug is not connected. Insert the plug.
The START button has not
been pressed.
The DELAYED START
option has been selected.
The water tap is closed (E10). Open the water tap.
The water inlet hose is
squashed or kinked (E10).
The small filter of the water
inlet hose is clogged (E10).
The door is not properly
closed (E40).
The end of the drain hose
is too low.
The drain hose is
squashed or kinked (E20).
The drain pump or the
drain hose are clogged (E20). the hose.
The RINSE HOLD option
(stop with water in drum)
has been selected.
The laundry is not evenly
distributed inside the drum. manually in the drum.
Something not working?
Solution
Close the door; the click
of the lock should be heard.
Press the button.
Check the selected delay on
the display.
Check the whole length of the
hose and remove the kink.
Clean the filter.
Close the door.
Place the hose at the right
height (see Installation
section).
Check the whole length of
the hose and remove the
kink.
Clean the pump or check
Empty out the water by
selecting the DRAIN or
SPIN programme.
Redistribute the laundry
39