Troubleshooting; Appendix; Specifications - Insignia NS-lcd19 User Manual

Insignia NS-LCD19 19" LCD TV

Troubleshooting

Warning
Do not try to repair your TV yourself. Refer all
service to a qualified service technician.
Symptom Possible solution
No power
No picture
Good picture but no
sound
Good sound but poor
color
Poor picture
Horizontal dotted line
"Ghost" or double image
Remote control does not
work
Snowy picture or noise
• Make sure that the power cord
is connected to your TV and a
power outlet.
• Unplug the power cord, wait 60
seconds, then plug the cord
back in and turn on your TV.
• Make sure that the video cables
are connected securely to the
back of your TV.
• Adjust the contrast and
brightness.
• Make sure that the correct
video mode is selected.
• Make sure that the incoming
signal is compatible.
• Make sure the antenna is
connected correctly.
• Check the closed caption
settings. Some TEXT modes
can block the screen.
• Increase the volume.
• Make sure that the sound is not
muted.
• Make sure that the correct
audio mode is selected.
• Adjust the contrast, color, and
brightness settings.
• Make sure that the room is not
too bright. Light reflecting off
the screen can make the picture
difficult to see.
• If an S-VHS camera or a
camcorder is connected while
another connected device is
turned on, the picture may be
poor. Turn off one or more
devices.
• Your TV may be too close to
another electrical device, such
as a hair dryer or neon light.
Turn off the device or move
your TV.
• This may be caused by
obstructions to the antenna,
such as high-rise buildings or
hills. Use of a highly directional
antenna may improve the
picture quality.
• Press the TV button.
• Replace the batteries. Make
sure that the + and – symbols
on the batteries align with the +
and – symbols in the battery
compartment.
• Clean the remote sensor on the
front of your TV.
• Bright or fluorescent lighting
may interfere with the remote
control signal. Turn off the light
or move your TV.
• Make sure that the A/V and
antenna cables are connected
correctly and securely.
www.insignia-products.com
Symptom Possible solution
VGA picture is not stable
or synchronized
No output from one of
the speakers
Control buttons do not
work
After images appear

Appendix

To attach a wall mount bracket to your TV:
1 Remove the four M4 screws holding your TV
to the stand.
2 Secure the wall mount bracket to the back of
your TV using four M4 screws, as indicated in
the illustration.
100 mm
Attach wall
bracket here
Remove M4 screws
Remove stand

Specifications

• Design and specifications are subject to
change without notice.
Analog standard NTSC
Digital standard ATSC, 8-VSB, Clear-QAM
Screen 19-inch
Channel coverage VHF: 2-13
UHF: 14-69
CATV: Mid band - A-8 ~ A-1, A ~ I
Power source AC 100-240 V 50/60 Hz
Power <80 W
consumption <1 W in standby mode
• Make sure that you have
selected the correct VGA mode
on your computer.
• Adjust the balance in the Sound
menu.
• Unplug the power cord, wait a
few seconds, then plug the cord
back in and turn on your TV.
• Do not display a still image,
such as a logo, game, or
computer image, for an
extended period of time. This
can cause a permanent after
image to be burned into the
screen. This type of damage is
not covered by your warranty.
M4 screws
100 mm
Remove M4 screws
Super band - J ~ W
Hyper band - AA ~ ZZ, AAA, BBB
Ultra band - 65 ~ 94, 100 ~ 135
13