Advertisement
The effects processor can be used
as a table top unit. The unit should
be situated so that its location or
position does not get affected by
the heat of the amplifier.
The effects processor must always
be powered through a 12V DC
adaptor, supplied alongwith.
Always insert the adaptor plug into
the 12V DC socket of the unit and
then connect the adaptor to an AC
mains outlet.
When foot switch is to be used,
always connect the foot switch to
the bypass jack socket of the
Preamp
MX-15
Output
MX-15
Aux Send
(Post Fade)
Mixing Console
DFX-160B (Rear Panel)
input
output
right
left (mono)
P r o S e r i e s
A M X - 1 6 1 2
Aux
Return
(L & R)
• Interconnections
effects processor before the power
is turned ON.
To avoid signal overloading,
distortion and to minimize the noise,
it is necessary to set the proper
signal levels at every point in the
send / return chain.
The connection diagrams that
follow display the typical types of
input sources and output
equipments which can be
connected to the effects processor.
For correct connections and
operation, check the specification of
the connected equipment.
footswitch
Foot Switch
ZONE-A
Aux
Input
BTZ-7000
Line
Input
SSA-250M
7
12V dc
12V DC Adaptor
Mic-1 Return
Mic-1 Send
ZONE-A
BTZ-7000
PSX-1200
SSA-250M
Hide quick links:
Advertisement
