Advertisement
Dive Light System Instruction Manual
Bulb(s)
Battery
Burn time
Dimensions
Waterproof/Weatherproof
Beam Angle
Water resistance
Weight
Warranty Info
* If the dive light system fails to operate properly after reading through the manual and troubleshooting guide, contact your
local dealer or Nocturnal Lights technical support. Additional help can also be found at our website:
http://www.nocturnallights.com
3 YEAR LIMITED WARRANTY – Nocturnal Lights Inc. warrants this product to be free from defects in workmanship and materials
under normal use for 3 years from the purchase date. The product must be purchased from an authorized Nocturnal Lights
dealer and it is only valid for the original purchaser. This warranty does not cover deterioration due to normal wear and tear,
damage from misuse, alteration, negligence, accidents, or unauthorized repairs. Nocturnal Lights, Inc. will repair or replace
parts which are defective in workmanship or materials.
To be eligible for warranty service, you must have all original purchasing receipts.
Photo And Video Light Accessories (optional)
Adapters are available for the SLX 800t (converts to a 800i) if you intend to use it as a focus light or a video light for all
underwater photo and video housings. Trays, adapters, housing adapters, arms, and clamps can also be found on our
website. Please contact your local dealer or visit Nocturnallights.com for more information.
Technical Hand Mounts (optional)
Removing the handle on the SLX
Peel the rubber protective cap at the back of the lights towards the handle and you will see a screw that
connects the handle to the body of the light. The handle can be removed using a Philips screwdriver. Upon the
removal of the screw the handle may still be attached to the housing with glue. Apply some force and the handle
will be removed.
Neoprene Hand Mount
After you remove the handles you will still be able to open and close the housing completely by grasping the end of
the housing. Each neoprene hand mount comes with a light clamp. After inserting the light in the housing, wrap the
clamp around the hand mount and fasten securely. The hand mount comes with two straps, one narrow and one
wide. It is up to you to decide which strap will loop around your wrist DO NOT OVERTIGHTEN THE CLAMP.
Goodman Handle
To use the Goodman handle, simply remove the handle on the SLX and secure the handle from the back of the light.
You can adjust the height and the position of the light by using a Philips screwdriver. You should always use a lanyard
so you can let go of the light anytime while diving.
Triple High-Powered LED.
AA x6 Batteries
2 hours on max output – up to 8 hours
2 ¾" by 5 ½" w/o handle
Yes (double o-ring)
12 degrees to 60 degrees
100 meters (328 ft)
0.5lb (in water) 1.4 (outside)
Page 4
Advertisement
