Table of Contents
Advertisement
2
| DVP User Manual 4.0
Front Panel View (above)
The front panel consists of a power switch, IR receiver,
and an USB port.
1. Power Switch
This POWER button on the front of the unit will turn
the unit on and off. It is used in conjunction with the
main power switch on the rear of the unit.
1. Ensure power supply switch is in the ON position
(on back panel)
2. Start the unit by pressing the POWER button
2. IR Receiver
The IR Receiver is used with the included remote
control.
3. USB Port
The USB port can be used to offload media from and
to the DVP. It can also be used to set or capture an IP
address. See the Network Configuration section for USB
IP address configuration.
Use this information when you first purchase the DVP
and when you are ready to install the hardware at
your site. To turn on the unit ensure the power supply
switch is in the ON position then start the unit by
pressing the POWER button.
August 2009
1
2
3
Rear Panel View (below)
1. DC Power Connector - Input 100-240 VAC 50/60Hz
external power supply with 12VDC–3A output.
2. Audio - Three audio outputs consist of Stereo, Line
level, and 3.5mm Jack (PC audio type)
3. LAN/Ethernet - 10/100 Mb (RJ-45) input
4. USB 2.0/1.1 (Std. Type A) - The two USB ports can
be used for network configuration of the DVP. For
more information on USB network configuration, see
chapter 2.
5. S-video - One S-video output
6. HDMI - One HDMI output
7. VGA - HD-15 Female output connector for local
monitor. NOTE: THIS IS NOT A PC LOOP-THROUGH
8. DVI - One DVI output
9. Serial RS232 Port - Two DTE Male DB-9 connectors
used to attach a computer or other equipment for
serial control.
7
5
9
8
3
1
6
4
2
Advertisement
Table of Contents
