Advertisement
GAIN ADJUSTMENT
Set the amp gain to minimum, turn the source up until it just starts to distort, then
back down slightly. This is the point where the output of the source is cleanest.
Now adjust the amplifier gain up until it just starts to distort and back down
slightly. This will allow the source and amp to reach maximum usable output at
the same time.
MOUNTING
1. The amplifier will work best if it is kept as cool as possible. Mount in a position
that allows air to flow freely through the fins. Be sure there is ample space above
the amplifier to avoid trapping heated air rising from the amplifier. The amplifier
should not be mounted upside down. Avoid mounting any amplifier in the dash or
on the firewall to avoid noises being radiated directly into the case.
2. The case of your amplifier is designed to act as a noise shield. To maintain
this protection, be sure the metal case of the amp does not touch the metal of the
car. Do not remove or damage the rubber grommets, which provide electrical
insulation and vibration isolation.
GENERAL TROUBLESHOOTING
NO SOUND
Check all connections. Check main power fuse. Check accessory fuse of your
vehicle. Check to see that +12Vdc is present at the amplifier on the power wire,
and on the red/white remote turn-on wire. Check for a solid ground connection.
Check that the main music source is putting out signal.
BLOWS FUSES
Check all connections to be sure no wires are touching each other or the chassis
of the vehicle or any other equipment in your install. Check that your speakers
are in proper working order.
SHUTS OFF
These amplifiers are equipped with a Thermal Shutdown System. If the amplifier
becomes too hot during operation, it will shutdown until it cools to proper
operating temperature. This can be caused by lack of proper air circulation to the
amp, or too low of speaker impedance.
Advertisement
